IP1IP101G is an IEEE 802.3/802.3u compliant single-port Fast Ethernet Transceiver for both 100Mbps and 10Mbps operations. It supports Auto MDI/MDIX function to simplify the network installation and reduce the system maintenance cost. To improve the system performance, IP101G provides a hardware interrupt pin to indicate the link, speed and duplex status change. IP101G provides Media Independent Interface (MII) or Reduced Media Independent Interface (RMII) to connect with different types of 10/100Mb Media Access Controller (MAC). IP101G is designed to use category 5 unshielded twisted-pair cable or Fiber-Optic cables connecting to other LAN devices. A PECL interface is supported to connect with an external 100Base-FX fiber optical transceiver.
Except good performance, reliability, rich power saving method and extreme low operating current, IP101G provides a serial tool for system designers to complete their projects easily. They are System Debug Assistant Tool and EMI Management Tool.
IP101G is fabricated with advanced CMOS (85nm) technology and design is based on IC Plus’s 5th Ethernet-PHY architecture, this feature makes IP101G consumes very low power. Such as in the full load operation (100Mbps_FDX), it only takes below 0.15W.
IP101GA / IP101GR&IP101GRI are available in 48LQFP/32QFN, lead-free package.
Feature :
10/100Mbps IEEE 802.3/802.3u compliant Fast Ethernet transceiver
Supports 100-Base-TX/Fx Media Interface
Supports MII/ RMII Interface
Supports Auto MDI/MDIX function
Power Management Tool
- APS, auto power saving while Link-off
- 802.3az, protocol based power saving
- WOL+, light traffic power saving
- PWD, force-off power saving
Supports Base Line Wander compensation
Supports Interrupt function
Supports MDC and MDIO to communicate with the MAC
EMI Management Tool
- F/W based control
- 4 levels for mapping the difference layout length on the PCB
Single 3.3V power supply
Built-in Vcore regulator
DSP-based PHY Transceiver technology
System Debug Assistant Tool
- 16 bit RX counter
- 9 bit RXER/CRC counter
- Isolate MII/RMII
- RX to TX Loopback
- Loopback MII/RMII
Using either 25MHz crystal/oscillator or 50MHz oscillator REF_CLK as clock source
Built-in 49.9ohm resistors for simplifying BOM
Flexible LED display
Process: 85nm
Package and operation temperature
- IP101G: dice, 0~70℃
- IP101GA: 48LQFP, 0~70℃
- IP101GR: 32QFN, 0~70℃
- IP101GRI: 32QFN, -40~85℃
Feature :
NAS
Network Printers and Servers
IP Set-Top Box
IP/Smart TV
Game console
IP and Video Phone
PoE
Telecom Fiber device |
免责声明： 以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，企业录对此不承担任何责任。如有侵犯您的权益，请来信通知删除。